1、 Daily maintenance

Appearance inspection

The appearance of the generator set should be inspected daily to see if there is any damage, leakage, or accumulation of foreign objects. For example, checking for cracks in the casing and oil or water stains at the connections of oil and water pipes can help identify potential safety hazards in a timely manner. If a large amount of dust is found on the surface of the generator, it should be cleaned in a timely manner, as the accumulation of dust may affect the heat dissipation of the generator.

Fuel inspection

For generator sets that use diesel or gasoline as fuel, the fuel level should be checked regularly. Ensure that there is sufficient fuel in the fuel tank to meet the demand for emergency power generation. At the same time, check the quality of the fuel to prevent moisture or impurities from entering. If there is too much moisture in the fuel, it may cause difficulty in starting or unstable operation of the engine.

Lubricating oil inspection

Checking the oil level of lubricating oil is an important part of daily maintenance. Insufficient lubricating oil will increase the wear of engine components. It is also necessary to observe the color and texture of the lubricating oil. Under normal circumstances, the lubricating oil should be clear or slightly brown. If the lubricating oil is found to have turned black or thickened, it may be a problem inside the engine that requires further inspection.

Cooling system inspection

Check the water level of the cooling water tank to ensure that it is within the normal range. Check for leaks in the water pipes of the cooling system, as a malfunction in the cooling system may cause the engine to overheat. At the same time, check the operation of the cooling fan to ensure that it can work properly and provide sufficient cooling air volume for the engine.

2、 Regular testing

Start testing

Conduct at least one no-load start-up test per week to check the starting performance of the generator. Pay attention to the working condition of the starter motor, the starting speed of the engine, and the idle stability after starting. After running without load for a period of time, check whether the output voltage and frequency of the generator are within the normal range, which helps ensure that the generator can start and supply power normally in emergency situations.

Load testing

Conduct a load test once a month or quarter to simulate actual electricity usage and load a certain proportion of rated load. During the load testing process, check the output power, voltage regulation capability, and frequency stability of the generator. By conducting load testing, potential issues with the generator under load can be identified in a timely manner, such as insufficient output power and excessive voltage fluctuations.

Battery testing

Regularly (usually once a month) check the voltage and electrolyte density of the starting battery. Ensure that the battery is in good charging condition and can provide sufficient power for the generator to start. If the battery voltage is too low or the electrolyte density is abnormal, the battery should be charged or replaced in a timely manner.

Insulation resistance testing

Perform insulation resistance testing on the generator winding every six months. Measure the insulation resistance between the stator winding and rotor winding of the generator and the casing using an insulation resistance tester. Low insulation resistance may cause a short circuit in the generator, affecting its normal operation. Regular testing can detect insulation aging and other issues in advance, and take timely maintenance measures.